Notifications
Clear all
Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'
Prior to upgrading to 2.4.2 slicer on my Mac I could slice and then select send to printer or to sdcard. Now I only seem to have SDCARD as an option?
Where did the send to printer option go then?
Napsal : 21/06/2022 11:20 am
RE: Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'
Did you select a "physical printer" in the printer drop down, not a "preset"? I am also running 2.4.2 on a Mac and sending gcode to printer works as always.
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Napsal : 21/06/2022 11:26 am
Topic starter
answered:
RE: Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'
Preset now you mention it......
Will change that and try again - thanks !
Napsal : 21/06/2022 11:28 am