Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'
 
Notifications
Clear all

Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'  

  RSS
spamplin
(@spamplin)
New Member
Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'

Prior to upgrading to 2.4.2 slicer on my Mac I could slice and then select send to printer or to sdcard. Now I only seem to have SDCARD as an option? 

Where did the send to printer option go then? 

Posted : 21/06/2022 11:20 am
Robin
(@robin)
Reputable Member
RE: Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'

Did you select a "physical printer" in the printer drop down, not a "preset"? I am also running 2.4.2 on a Mac and sending gcode to printer works as always.

If at first you don't succeed, skydiving is not for you.

Posted : 21/06/2022 11:26 am
spamplin
(@spamplin)
New Member
Topic starter answered:
RE: Upgrade to 2.4.2 and I seem to have lost 'Send Gcode to printer'

Preset now you mention it...... 

Will change that and try again  - thanks ! 

Posted : 21/06/2022 11:28 am
Share: