Trying to improve Top Solid Infill results on a print
 
Notifications
Clear all

Trying to improve Top Solid Infill results on a print  

  RSS
rud
 rud
(@rud)
Active Member
Trying to improve Top Solid Infill results on a print

Hello community!

I am trying to print the Low Poly Fox ( https://www.thingiverse.com/thing:937740 ) on an I3 MK3s, using PrusaSlicer and the "0.20mm Quality MK3" profile.

When doing so, I notice that the top portion of the left ear and left foot appears to have a few of "red-steps-like-lines" (which I assume are Top Solid Infills in the picture).

Is there any PrusaSlicer setting I could tweak in order to get a better print result for these areas of the print ?

Thank you !

Posted : 03/12/2019 1:55 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Trying to improve Top Solid Infill results on a print

Hi Rudolph, 

You could try reducing the layer height to make the steps less obvious

 

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 04/12/2019 1:20 am
Share: