Support calculation error
Dear all,
I made an STL with Tinkercad and wanted to slice it for printing as usual, but I got a strange issue, at one point where there should be, no support is calculated.
How can I fix it or force a support?
Thank you in advance,
Zsolt
RE: Support calculation error
have you got 'Don't support bridges' ticked? in the support settings
that might give the issue that you describe
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility.Location Halifax UK
RE: Support calculation error
Dear Joan,
Thank you very much, that was the issue. I didn't even know that there was an option like that.
What is the point in that anyway?
Regards
Zsolt
RE: Support calculation error
it's an old option, i believe it was originally intended to save filament on prints.
many short bridges, do not need supports.
lots of people notice the lack of supports and think it is a slicing fault.
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility.Location Halifax UK