Notifiche
Cancella tutti

Support Artifacts on Model  

  RSS
Cobalt Echo
(@cobalt-echo)
Active Member
Support Artifacts on Model

PrusaSlicer seems to be adding a lot of support artifacts on top of the model, I've provided two links below.  I have the settings as identical as possible.

The model is of an eagle:

Prusa Slicing: https://imgur.com/7Ni1sb7

Cura Slicing: https://imgur.com/M6qzQ4I

Both pictures (Album): https://imgur.com/a/D1RbF8m

I have the .3mf file avaiable if anyone wants to look at it.  Any suggestions would be appreciated!  The prints from PrusaSlicer typically come out nicer then if I use Cura, but not sure why it's adding all the extra artifacts.

Questa discussione è stata modificata 4 years fa da Cobalt Echo
Postato : 20/10/2020 11:37 pm
Condividi: