Benachrichtigungen
Alles löschen
Support Artifacts on Model
PrusaSlicer seems to be adding a lot of support artifacts on top of the model, I've provided two links below. I have the settings as identical as possible.
The model is of an eagle:
Prusa Slicing: https://imgur.com/7Ni1sb7
Cura Slicing: https://imgur.com/M6qzQ4I
Both pictures (Album): https://imgur.com/a/D1RbF8m
I have the .3mf file avaiable if anyone wants to look at it. Any suggestions would be appreciated! The prints from PrusaSlicer typically come out nicer then if I use Cura, but not sure why it's adding all the extra artifacts.
Dieses Thema wurde geändert Vor 4 years von Cobalt Echo
Veröffentlicht : 20/10/2020 11:37 pm