Notifications
Clear all
Strange Z offset Issue
New to Prusaslicer but feel it will work better than Cura on the Anycubic Kobra 2 NEO. The issue I am having is that the printer is fully tuned and printing fine using the Anycubic Slicer (entry level slicer), Printer Z offset set -1.81, slice with AS and first layer good, slice with PS and I have to lower Z offset to -2.21. I have checked around and believe that the PS Z offset setting should be set to O to allow the printer firmware to set z offset. My son also uses the unit (AS slicer) and already has scratched the bed because I didn't set it back to -1.81 following my testing. Is there something that I am missing? Is this an PS thing or a Marlin issue? I appreciate any assistance you can give me, thanks.
Posted : 05/10/2023 3:40 am