Something is wrong with the prints  

RE: Something is wrong with the prints

It's in the video. Looks fine to me.

Posted by: @hello

How's your first layer look. Can you please print the flexy octopus also in prusa slicer where it says super detail change it to draft or 1 above draft

RE: Something is wrong with the prints

sorry didint even see your post um yes it could be because of feeding problems im just lookin gat the video now

RE: Something is wrong with the prints

since its looking to be a hardware fault may i recomend redit

RE: Something is wrong with the prints

Thanks.
You mean you recommending me to ask in redit about this problem, and ask them if it's a hardware one? 

Posted by: @hello

since its looking to be a hardware fault may i recomend redit

RE: Something is wrong with the prints

Posted by: @ymca

Thanks.
You mean you recommending me to ask in redit about this problem, and ask them if it's a hardware one? 

Posted by: @hello

since its looking to be a hardware fault may i recomend redit

 

Yes because I don't own one of theme and no one who has picked in has one and it's definitely not a slicer issue 

I'm sorry I carnt be of further assistance 

RE: Something is wrong with the prints

No one knew about this problem.
I finally found it and fixed it.
There were two problems.
One is that the long screw that the motor was moving up and down on, was not quite straight.
I pushed it a bit and heard a click.
Then saw the fillament was broken so I inserted the good part.
I saw it wasn't pulling the fillament so I searched for a fix.
Then I took it apart and put it together and didn't skrew it hard.
That's it. The printing cube was fine. 😍