Something is wrong with the prints
 
Notifications
Clear all

Something is wrong with the prints  

Stránka 2 / 2
  RSS
ymca
 ymca
(@ymca)
Eminent Member
Topic starter answered:
RE: Something is wrong with the prints

It's in the video. Looks fine to me.

Posted by: @hello

How's your first layer look. Can you please print the flexy octopus also in prusa slicer where it says super detail change it to draft or 1 above draft

 

Napsal : 30/07/2023 11:36 pm
Hello
(@hello)
Noble Member
RE: Something is wrong with the prints

sorry didint even see your post um yes it could be because of feeding problems im just lookin gat the video now

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Napsal : 31/07/2023 12:24 am
Hello
(@hello)
Noble Member
RE: Something is wrong with the prints

since its looking to be a hardware fault may i recomend redit

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Napsal : 31/07/2023 1:13 am
ymca
 ymca
(@ymca)
Eminent Member
Topic starter answered:
RE: Something is wrong with the prints

Thanks.
You mean you recommending me to ask in redit about this problem, and ask them if it's a hardware one? 

Posted by: @hello

since its looking to be a hardware fault may i recomend redit

 

Napsal : 03/08/2023 10:05 pm
Hello
(@hello)
Noble Member
RE: Something is wrong with the prints

 

Posted by: @ymca

Thanks.
You mean you recommending me to ask in redit about this problem, and ask them if it's a hardware one? 

Posted by: @hello

since its looking to be a hardware fault may i recomend redit

 

Yes because I don't own one of theme and no one who has picked in has one and it's definitely not a slicer issue 

I'm sorry I carnt be of further assistance 

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Napsal : 04/08/2023 8:07 am
ymca se líbí
ymca
 ymca
(@ymca)
Eminent Member
Topic starter answered:
RE: Something is wrong with the prints

No one knew about this problem.
I finally found it and fixed it.
There were two problems.
One is that the long screw that the motor was moving up and down on, was not quite straight.
I pushed it a bit and heard a click.
Then saw the fillament was broken so I inserted the good part.
I saw it wasn't pulling the fillament so I searched for a fix.
Then I took it apart and put it together and didn't skrew it hard.
That's it. The printing cube was fine. 😍 

Napsal : 27/10/2023 11:23 pm
Stránka 2 / 2
Share: