Notifications
Clear all
Sequential printing and brim
When 'complete individual objects' is enabled the brim gets printed first for all the objects and this is somewhat counterproductive if one experiences some 1st layer adhesion issues, for e.g. with Polymaker's PC MAX using the Satin sheet.
My Z and bed levelling are just fine judging from the thickness of 6x6 calibration grid. I also have a custom enclosure and the temperature inside is 50c before starting with PC.
The issue is that the brims cool down and when the nozzle goes back to start printing the actual object sometimes it snags the brim (which is now cold and hard).
When I set 'complete individual objects' each brim+object should be printed in 1 go, no?
Napsal : 29/07/2023 7:40 pm
Ty a se líbí