Čeština
Fóra
English forum
Prusa software & others
PrusaSlicer
Preview PrusaSlicer 2.3 Vs Simplify3D
 
Notifications
Clear all

Preview PrusaSlicer 2.3 Vs Simplify3D  

    Poslední Příspěvek
  RSS
Jordao
 Jordao
(@jordao)
New Member
Preview PrusaSlicer 2.3 Vs Simplify3D

Hello to all the community


I would like to know if there is a possibility of better rendering in Prusaslicer to detect perimeter overlaps.
indeed, when cutting a part, PrusaSlicer did not show me any particular rendering problem but once the part was printed,
artefacts appeared on the wall which was supposed to be smooth I think that by printing the inner perimeter,
the nozzle has come to overlap the other perimeter and created an extra thickness.

My print settings were with a 0.4 nozzle and 0.3mm height in PLA. The thickness of the recess inside the part should be 0.8mm.
 
I understood where my problem was but While chatting with a friend he showed me that on Simplify3D the rendering was different and showed exactly
how the part was going to be printed (CURA also doesn't show the problem)

Napsal : 22/01/2021 8:50 pm
bobstro
 bobstro
(@bobstro)
Illustrious Member
RE: Preview PrusaSlicer 2.3 Vs Simplify3D

You didn't mention exactly what the feature was that you need to see, but you can enable additional features in PrusaSlicer's preview, including travel, wipe, and retraction.

If you're after something else, it would be helpful if you'd save your part & settings off in a 3MF project file, zip it, and attach it to a reply here so we can see the specifics.

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Napsal : 22/01/2021 9:00 pm
Jordao
 Jordao
(@jordao)
New Member
Topic starter answered:
RE: Preview PrusaSlicer 2.3 Vs Simplify3D

Hello,

Thank you for your answer.

I tried to link you in the message with the STl + .3mf file of the part I printed. As you can see the rendering on Prussaslicer looks good but once I printed I saw some extra thickness on the smooth side of the part. It's an extrusion width issue I think and found the solution but I wish Prusaslicer had shown me exactly how the part was going to print rather than finding out on print. By comparing with Simplify3D, this shows exactly how the part will print so we can act accordingly, modify the settings, modify the part ... etc.

 

 

 

Napsal : 26/01/2021 7:53 am
  All forum topics
  Previous Topic
Next Topic  
Share: