Benachrichtigungen
Alles löschen
Perfect print with spiral vase shell but fails with it turned off
My print is working fine with the spiral vase shell option on (flow rate test).
As soon as I turn it off the print fails at the 5mm height each time. I have changed MANY settings with the same results.
Prusaslicer is not showing any differences in the whole print after the 1st layer.
Any hints on why this might be happening?
This is ASA filament printing @ 240 and 90 degrees. Ender3 printer.
Veröffentlicht : 01/08/2023 4:45 pm