Notifications
Clear all
Odd support issues
I've been getting this more and more.
I have a model that has printed fine in the past, PrusaSlicer is adding supports to support nothing.
IE: a helmet is sliced with a blocker in the middle, or with enforcers used in specific locations, The slicer is adding support where needed, but also random support that supports nothing and is either not part of the enforced area, or in the blocker.
Anyone seen this and know how to stop it?
Opublikowany : 18/06/2021 12:43 am
RE: Odd support issues
A lot of folks are posting issues with supports. Can you post an image or a zipped file so we can see it?
--------------------
Chuck H
3D Printer Review Blog
Opublikowany : 18/06/2021 2:39 pm