New to PrusaSlicer - blobs and zits
Hello
many times I tried to use Slic3r and prusa slic3r and now PrusaSlicer
It gets better and better and I'll like to adopt it as my main slicer.
Print surfaces are nice but I encounter some troubles with little blobs on outer surfaces, similar but smaller than these from S3D guide.
I use random/nearest seam position on conic/cilindrical prints and blobs.
My machine has bowden.
I used the same parameters I use in S3D but in S3D there is the coast at end parameter that isn't available in PS (I didn't see it)
I know that prusa printers have linear advance to correct these artifacts. My printer doesn't..
Can you suggest some work around?
Thanks
Pietro
RE: New to PrusaSlicer - blobs and zits
Ciao, ti rispondo in italiano perchè vedo che sei italiano, anche io sto usando prusa slicer con una Ender3 ed anch'io a volte riscontro il tuo problema, solo a volte su alcuni layers, altri sono perfetti, non capisco perchè questa discontinuità, magari visto che qua non risponde nessuno potremmo scambiarci informazioni. Hai risolto?