MK3s boşluk doldurma problemi
Hi,
My device: Mk3s - MMU2s
Slicer: PrusaSlicer 2.2.0 rc2 (Old versions have the same problem)
I have problems with small articles. There are gaps between the walls.
Do you have suggestions for me to solve these problems? In the Cura program, there was the option to fill the wall gaps. Does PrusaSlicer include this?
My settings and sample pictures below. (Language = Turkish)
Thank you so much in advance.
RE: MK3s gap filling problem
Sorry Turkish Tittle.
MK3s gap filling problem
RE: MK3s boşluk doldurma problemi
That doesn’t look like a gap between walls, it looks like a gap between the infill and the walls to me.
Also without being at my pc and comparing the settings I can’t tell what the settings are, but I’m assuming you do have gap fill enabled ?
RE: MK3s boşluk doldurma problemi
That doesn’t look like a gap between walls, it looks like a gap between the infill and the walls to me.
Also without being at my pc and comparing the settings I can’t tell what the settings are, but I’m assuming you do have gap fill enabled ?
Where is the gap filling setting?
RE: MK3s boşluk doldurma problemi
I printed the letter R in single and multi mode one and there was no problem.
