FLOW RATE ignored in 2.5.0 Alpha 2
 
Notifiche
Cancella tutti

FLOW RATE ignored in 2.5.0 Alpha 2  

  RSS
audry
(@audry)
New Member
FLOW RATE ignored in 2.5.0 Alpha 2

I try to calibrate my printer using calculated flow rate using a single cube 20x20x20

Slicer ignores flow rate, and always requires the same filament length regardless of setup

It also ignores the filament start GCODE where I put the M221 statement, however the GCODE is commented at the end of the file.

Is it a bug or do I use the software the wrong way?

 

Postato : 29/07/2022 1:22 pm
Swiss_Cheese
(@swiss_cheese)
Noble Member
RE: FLOW RATE ignored in 2.5.0 Alpha 2

OK so try alpha 3 it's been out for  a week or so and report back.

 

Regards

 

Swiss_Cheese

The Filament Whisperer

Postato : 29/07/2022 3:37 pm
audry
(@audry)
New Member
Topic starter answered:
RE: FLOW RATE ignored in 2.5.0 Alpha 2

Thanks

 

Tried 2.5.0 Alpha 3

What works now:  Filament start GCODE is expanded

What is still broken: Slicer still ignores Flow Rate parameter

I will use GCODE until the parameter is working, no issue 

 

Thanks for info 

Postato : 30/07/2022 6:13 am
Condividi: