Feature request: allow variable layer height above the last bit of organic support
 
Notifications
Clear all

Feature request: allow variable layer height above the last bit of organic support  

  RSS
Johnomaz
(@johnomaz)
Active Member
Feature request: allow variable layer height above the last bit of organic support

I know I can't get variable layer height because of organic supports  but after the last bit of support is printed, anything above that should be allowed to be variable.  I want the smoothness of small layer heights on the top of models with curves.  

Posted : 21/06/2024 4:21 am
Neophyl
(@neophyl)
Illustrious Member
RE: Feature request: allow variable layer height above the last bit of organic support

All feature requests need to be made at the Prusa Slicer github here https://github.com/prusa3d/PrusaSlicer/issues   

This is a user to user forum and does not get much Dev interaction.

However this is already an open issue https://github.com/prusa3d/PrusaSlicer/issues/9462   

Posted : 21/06/2024 4:57 am
Share: