Notifications
Clear all
Feature request: allow variable layer height above the last bit of organic support
I know I can't get variable layer height because of organic supports but after the last bit of support is printed, anything above that should be allowed to be variable. I want the smoothness of small layer heights on the top of models with curves.
Napsal : 21/06/2024 4:21 am
RE: Feature request: allow variable layer height above the last bit of organic support
All feature requests need to be made at the Prusa Slicer github here https://github.com/prusa3d/PrusaSlicer/issues
This is a user to user forum and does not get much Dev interaction.
However this is already an open issue https://github.com/prusa3d/PrusaSlicer/issues/9462
Napsal : 21/06/2024 4:57 am