Notifications
Clear all
Page 9 / 9
Précédent
RE: eSun ePA-CF, Carbon Fibre Slicer Profile.
@Bul
I recently did a few prints with this filament (first time i used it). It was on my XL with enclosure and 0.4 nozzle. The results were excellent. I printed an idler mod for my extruder with 0.15 layer and a cylindrical threaded box without supports. After reading this post i dried it for 14h on 80 degrees (maybe a bit overkill but ...) and printed it using the Prusament PA11 Cf as a base and altering the following
280 printing temp
65 degrees bed
1.1 Extrusion multiplier
2.5 retraction length
I dont have an image of the results but it was rigid, clean print with no stringing.
Publié : 04/10/2025 9:10 am
Page 9 / 9
Précédent