Disable autoarrange after a cut

Ultimi post

RSS

Ren

(@ren)

Eminent Member

Disable autoarrange after a cut

I was thinking, is there any way how to stop Prusaslicer from moving model after cutting it? After cutting and leaving only bottom part it is always autoarranged/centered, which turns printing of inlays into a little nightmare.

Postato : 24/10/2021 4:53 pm

Statistiche Forum

565 Forum

63.6 K Discussioni

446.1 K Post

20 Online

68.9 K Utenti

Post recenti: MK4S Upgrade X & Y layer shifts by 20mm Ultimo utente registrato: Kiley Murphy Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso