Built-in calibration tools in Prusa Slicer?
Hi,
I'm not sure if this is the right place to ask, but I was wondering: Are there any plans to add built-in calibration tools in Prusa Slicer similar to what's available in other slicers like Orca and Cura? This would be a huge time saver if it was all built right into the slicer.
Thanks,
Julien
Best Answer by Neophyl:
The correct place to ask is the Prusa Slicer github pages. Dont open a new issue though as it would be a duplicate issue. For example this one from March https://github.com/prusa3d/PrusaSlicer/issues/9916 or https://github.com/prusa3d/PrusaSlicer/issues/6168
Like suggested in 6168 you might want to look at the calibration tools from Super Slicer 2.4.58. SuSi is built on PS and so many of the settings will be applicable.
RE: Built-in calibration tools in Prusa Slicer?
The correct place to ask is the Prusa Slicer github pages. Dont open a new issue though as it would be a duplicate issue. For example this one from March https://github.com/prusa3d/PrusaSlicer/issues/9916 or https://github.com/prusa3d/PrusaSlicer/issues/6168
Like suggested in 6168 you might want to look at the calibration tools from Super Slicer 2.4.58. SuSi is built on PS and so many of the settings will be applicable.