Notifications
Clear all
Page 2 / 2
Prev
RE: Troubleshooting - looking for ideas
I believe the OP's file had a lot of extra gcode. What was that for?
Which g-code are you referring to? The only extra bit I see is for a nozzle wiper.
Posted : 13/02/2026 12:23 am
RE: Troubleshooting - looking for ideas
Ah, I'm confusing with another print. This just has the M572 code. Brings me to another OT question. I can reply to any post but can't post a new topic here myself. Buttons do nothing. So, is there a good G-code cheat sheet for the more commonly used functions, with usage examples?
Posted : 13/02/2026 12:45 am
I'm still using a lightly modified food dehydrator, cheap and (with my mods) capable of drying up to four spools.
Cheerio,
Posted : 13/02/2026 8:00 am
Prusa specific gcodes
https://help.prusa3d.com/article/prusa-firmware-specific-g-code-commands_112173
https://help.prusa3d.com/article/buddy-firmware-specific-g-code-commands_633112
Cheerio,
Posted : 13/02/2026 8:24 am
Page 2 / 2
Prev