No longer Auto Parking on single filament print after MMU install

Ultimi post

RSS

imattis

(@imattis)

Active Member

No longer Auto Parking on single filament print after MMU install

After I installed the MMU, the gantry no longer auto parks to rear after completion of a single color print. This is important to me because I have the Buddy Camera for monitoring prints. Any ideas are appreciated. Thanks.

Postato : 25/11/2025 12:56 pm

Statistiche Forum

595 Forum

69.2 K Discussioni

483.8 K Post

15 Online

78.3 K Utenti

Post recenti: HT Hotend nozzles? Ultimo utente registrato: Magnus😺 Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso