[Risolto] Bed Leveling Failed on CoreONE upgrade

Pagina 3 / 3 Precedente

Ultimi post

RSS

StanleyB

(@stanleyb)

Active Member

RE: Bed Leveling Failed on CoreONE upgrade

I'll suggest one more thing: sometimes it's worth switching to manual Z-axis movement and going all the way down to Z=275. If the motors whine, it means the bed has mechanically leveled. Maybe this will help someone.

Postato : 09/01/2026 11:22 pm

hyiger

(@hyiger)

Noble Member

RE: Bed Leveling Failed on CoreONE upgrade

Posted by: @stanleyb

I'll suggest one more thing: sometimes it's worth switching to manual Z-axis movement and going all the way down to Z=275. If the motors whine, it means the bed has mechanically leveled. Maybe this will help someone.

Or just run Z Alignment Calibration from the UI.

Postato : 09/01/2026 11:54 pm

Pagina 3 / 3 Precedente

Statistiche Forum

595 Forum

69.9 K Discussioni

489.6 K Post

14 Online

80.7 K Utenti

Post recenti: After Core One + upgrade to Core one filament will not pass new assembly Ultimo utente registrato: SciPrint Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso