Notifications
Clear all
Filament sensor (side)-error
I experience multiple warnings of the printer running out of filament, with a question to demand to unload the filament-end ... but while there is still a full spool attached.
ALrready disassembled the filament-sensor-housing, cleaned it .. but no improvement.
I only experience this with toolhead 1, sensor 1.
This happened just a once in the first week of using the printer ... but last week 4 times while executing a print .. and now the sensor does not even see any filament, as the sensor gives a NINS-signal (I checked INFO).
Guess I'll have to contact 24/7-support?
Publié : 20/01/2024 7:20 pm
RE: Filament sensor (side)-error
Guess I'll have to contact 24/7-support?
Yes
Publié : 22/01/2024 11:27 am