Notifications
Clear all

Filament sensor (side)-error  

  RSS
ludodg
(@ludodg)
Estimable Member
Filament sensor (side)-error

I experience multiple warnings of the printer running out of filament, with a question to demand to unload the filament-end ... but while there is still a full spool attached.

ALrready disassembled the filament-sensor-housing, cleaned it .. but no improvement.
I only experience this with toolhead 1, sensor 1.

This happened just a once in the first week of using the printer ... but last week 4 times while executing a print .. and now the sensor does not even see any filament, as the sensor gives a NINS-signal (I checked INFO).

Guess I'll have to contact 24/7-support?

Posted : 20/01/2024 7:20 pm
Marc
 Marc
(@marc-9)
Estimable Member
RE: Filament sensor (side)-error

 

Posted by: @ludodg

Guess I'll have to contact 24/7-support?

Yes

Posted : 22/01/2024 11:27 am
Share: