Notifications
Clear all

Random pauses in prints since upgrading to 6.1.3-7898  

  RSS
jmorrison7
(@jmorrison7)
New Member
Random pauses in prints since upgrading to 6.1.3-7898

have a 2 tool head XL and i get random pauses in prints. I am doing 1 color only so no tool head changes, it has the latest firmware 6.1.3-7898.

It does not always happen.I currently have a 10+ hour print running, I started it about 9pm last night assumed it would end by the morning, I woke up to it at 41% complete and just sitting there. I restarted it and it paused again at 44%, restarted just now. I don't remember this happening with 6.1.2.

Since upgrading to 6.1.3  (2-3 days ago) i have not seen a USB error, but these pauses are just as annoying. I long for the days where i could start a print and walk away knowig it would finish without human intervention

Anyone else seen this and have suggestions?

Posted : 05/11/2024 3:53 pm
jmorrison7
(@jmorrison7)
New Member
Topic starter answered:
RE:

I did get the file to finish printing, and I restarted the exact file to print again. It Paused at 15%, 60% and 62%. When trying to resume at 62% the system crashed, red lights came on and printer went to a state with no print running. so 4-5 hours lost, I have restarted the print again, hopefully it will complete. 

 

I did disable the network, after upgrading to 6.1.3-7898 i connected to my wifi network to use Prusa Connect, that also had issues so i disabled that before the 1st print, don't think i will re-enable that. 

This post was modified 1 month ago by jmorrison7
Posted : 06/11/2024 6:49 am
Razor
(@razor)
Estimable Member
RE: Random pauses in prints since upgrading to 6.1.3-7898

Did it finish?

Mini+MK3S+XL 5 Tool

Posted : 14/11/2024 9:22 pm
jmorrison7
(@jmorrison7)
New Member
Topic starter answered:
RE: Random pauses in prints since upgrading to 6.1.3-7898

yes, as long i you hit resume, but it could be sitting there for hours on an overnight print. 

Posted : 15/11/2024 1:00 am
Share: