Filament run out swap to 2nd toolhead Have they implemented it?
 
Notifications
Clear all

Filament run out swap to 2nd toolhead Have they implemented it?  

  RSS
Moto Skwid
(@moto-skwid)
Active Member
Filament run out swap to 2nd toolhead Have they implemented it?

Does the XL 5T have a filament swap feature implemented yet? I looked it up and see some posts back in 2023 but I dont see anything current.  Basically an automatic feature to print from a 2nd tool head when filament runs out.  So you start with your short-end roll of filament on say tool 2 then it would pick up printing with the 2nd tool head for example T3 for long prints or to manage filament rolls that are almost out of filament. 

A lot of peps asking for this, it's such an obvious feature?  

Posted : 04/04/2024 5:14 pm
bapski
(@bapski)
Estimable Member
RE: Filament run out swap to 2nd toolhead Have they implemented it?

Spool Join feature. You can assign up to 4 other tookheads(if you have a 5 toolhead xl)

MY MODELS AT PRINTABLES
Posted : 04/04/2024 5:16 pm
Moto Skwid
(@moto-skwid)
Active Member
Topic starter answered:
RE: Filament run out swap to 2nd toolhead Have they implemented it?

This is very cool!! Thanks man. 

Posted by: @bapski

Spool Join feature. You can assign up to 4 other tookheads(if you have a 5 toolhead xl)

 

Posted : 04/04/2024 5:34 pm
Share: