Notifications
Clear all
Filament run out swap to 2nd toolhead Have they implemented it?
Does the XL 5T have a filament swap feature implemented yet? I looked it up and see some posts back in 2023 but I dont see anything current. Basically an automatic feature to print from a 2nd tool head when filament runs out. So you start with your short-end roll of filament on say tool 2 then it would pick up printing with the 2nd tool head for example T3 for long prints or to manage filament rolls that are almost out of filament.
A lot of peps asking for this, it's such an obvious feature?
Napsal : 04/04/2024 5:14 pm
RE: Filament run out swap to 2nd toolhead Have they implemented it?
Spool Join feature. You can assign up to 4 other tookheads(if you have a 5 toolhead xl)
Napsal : 04/04/2024 5:16 pm
Moto Skwid se líbí
Topic starter
answered:
RE: Filament run out swap to 2nd toolhead Have they implemented it?
This is very cool!! Thanks man.
Spool Join feature. You can assign up to 4 other tookheads(if you have a 5 toolhead xl)
Napsal : 04/04/2024 5:34 pm