Notifications
Clear all

Adjustment request for nozzle tool recalibration  

  RSS
gltovar
(@gltovar)
Active Member
Adjustment request for nozzle tool recalibration

I have a 5 tool xl, and I just swapped out a nozzle.  I subsequently performed the the nozzle recalibration, expecting it to recalibrate only the changed nozzle but it started to do all of them.  Not expecting this, I had some nozzles with gunk on them. Part of the process should allow for an optional chance to clean off all the nozzles before starting if a single nozzle recalibration isn’t possible. 🙂

Napsal : 18/05/2024 2:02 am
gltovar
(@gltovar)
Active Member
Topic starter answered:
RE: Adjustment request for nozzle tool recalibration

ah wait, it totally asks this, I just autopiloted past the message. Never mind!

Napsal : 18/05/2024 2:12 am
antfurn
(@antfurn)
Eminent Member
RE: Adjustment request for nozzle tool recalibration

100% agree there should be a way to just recalibrate a single tool head nozzle.

Napsal : 21/05/2024 12:08 pm
Share: