Notifications
Clear all
Mismatching resin sensor behaviour
- SL1S received less than month ago.
- Normal situation is that the printer proposes ~40-50% fill but even with 70% fill the printer complaints that there is not enough resin.
- After each print there is tens of %'s of unused resin left.
Napsal : 14/01/2022 7:30 am
RE: Mismatching resin sensor behaviour
I have noticed this too. If it gives me the option to print anyway, I select that. Have never run out of resin.
Mk3S+,SL1S
Napsal : 14/01/2022 2:56 pm
RE: Mismatching resin sensor behaviour
I've been getting overfill alerts, I just restart the print and it's fine. Go figure.
Napsal : 04/02/2022 9:41 pm