Notifications
Clear all

Mismatching resin sensor behaviour  

  RSS
Petri
(@petri)
Eminent Member
Mismatching resin sensor behaviour
  • SL1S received less than month ago.
  • Normal situation is that the printer proposes ~40-50% fill but even with 70% fill the printer complaints that there is not enough resin.
  • After each print there is tens of %'s of unused resin left.

 

Posted : 14/01/2022 7:30 am
sylviatrilling
(@sylviatrilling)
Honorable Member
RE: Mismatching resin sensor behaviour

I have noticed this too. If it gives me the option to print anyway, I select that. Have never run out of resin.

Mk3S+,SL1S

Posted : 14/01/2022 2:56 pm
Mr P
 Mr P
(@mr-p)
New Member
RE: Mismatching resin sensor behaviour

I've been getting overfill alerts, I just restart the print and it's fine. Go figure.

Posted : 04/02/2022 9:41 pm
Share: