Notifications
Clear all
Can the MK3/3.5 be embiggened?
Basically I want to build a custom rig based on the MK3/3.5. Is there anything hard coded in the firmware that would keep this from working?|
Does just altering the bed size in PrusaSlicer get the job done?
Does the mesh bed leveling operate on set distances? Or, does it probe a 7x7 grid based on dividing the overall bed size?
Also, I have seen people mention that the Prusa gantry system is not easily scalable. Does anyone have any idea what this may pertain to? Because I just don't see the issue.
Thanks,
Chip
Opublikowany : 03/08/2024 9:59 pm
Onno polubić