Notifications
Clear all

Can the MK3/3.5 be embiggened?  

  RSS
Chip Wallace
(@chip-wallace)
Active Member
Can the MK3/3.5 be embiggened?

Basically I want to build a custom rig based on the MK3/3.5.  Is there anything hard coded in the firmware that would keep this from working?|

Does just altering the bed size in PrusaSlicer get the job done?

Does the mesh bed leveling operate on set distances? Or, does it probe a 7x7 grid based on dividing the overall bed size?

Also, I have seen people mention that the Prusa gantry system is not easily scalable.  Does anyone have any idea what this may pertain to?  Because I just don't see the issue.

Thanks,
Chip

Napsal : 03/08/2024 9:59 pm
Onno se líbí
Share: