Notifiche
Cancella tutti
Supported filaments
Does Prusa support printing peba, morphlex, PLA-HR, If so, what settings (printing speed, temps, and other details) would work best?
Postato : 22/05/2026 6:43 am
Peba is extra flexible - on my Mk3 the idler pressure was really tricky to set. I haven't tried with the XL but I suspect it would be impossible with reverse bowden tubes so feed direct to the head...
Otherwise print it like extra soft TPU - slow right down and dial up the retraction.
Cheerio,
Postato : 22/05/2026 9:48 am