Open Source Prusa Firmware forum?
Is there a forum anywhere that discusses the Prusa Open Source Firmware, for people making modifications to it?
Can anyone please provide a link to such forums?
RE: Open Source Prusa Firmware forum?
Look in there: https://github.com/prusa3d
There are repos for different firmware architectures and for PrusaSlicer.
RE: Open Source Prusa Firmware forum?
Yes, that's where I acquired the open source code for the firmware, but I don't see anything on that GitHub page that's a forum for people to discuss the source code.
RE: Open Source Prusa Firmware forum?
Did you look under "Issues" and "Pull requests" in the sections? Anyhow that is where the changes happen and where the people are that make them. Anywhere else is probably wasted resources.
RE: Open Source Prusa Firmware forum?
As forum section for MK3.5 it would be User mods, enclosures, nozzles, ...
Due to the fact that PRUSA is in charge of develop and modify the FW (and you void the printer warranty if you decide to use your own FW), any unofficial modification of the FW is considered a user's MOD, so it must be discussed in the mods section.
PrusaSlicer has its own section in the forum, but the section is for general help, and there are no discussions between Prusaslicer mod developers.
If PRUSA would discover that there are so many people around that develop and test their own forks of Firmware and PrusaSlicer, they would be probably happy to add the relative sections to the forum.
Regards