Notifications
Clear all
Starting position of nozzle when using MMU3
Hi everyone, I have noticed that the distance between the nozzle and the bed is very close when loading material via the MMU3 on an initial print. It seems to have caused a few jams as the material is being pushed out but nowhere to go.
I'd like to change the starting nozzle point so it's a wee bit higher and then dropping down for the normal wipe before a print. I am however unsure what to change in the starting gcode on my mk3s+. Can any one offer a guidance?
Opublikowany : 28/12/2023 9:07 pm