Notifications
Clear all

Starting position of nozzle when using MMU3  

  RSS
Mezzauk
(@mezzauk)
Eminent Member
Starting position of nozzle when using MMU3

Hi everyone, I have noticed that the distance between the nozzle and the bed is very close when loading material via the MMU3 on an initial print. It seems to have caused a few jams as the material is being pushed out but nowhere to go.

 

I'd like to change the starting nozzle point so it's a wee bit higher and then dropping down for the normal wipe before a print. I am however unsure what to change in the starting gcode on my mk3s+. Can any one offer a guidance? 

Posted : 28/12/2023 9:07 pm
Share: