Notifiche
Cancella tutti
MMU3 Filamant Change Error
Help, for two weeks I have been trying to finish a two-color print, but it always stops in the layer with the filament change.
He successfully loads the filament into the nozzle and then pulls it back again. He does that three times and then comes an error message. But if I press the nozzle load via the menu, everything works normally! I've resliced the model several times, but it doesn't help.
I am desperate, please help, thank you!!!
Questa discussione è stata modificata 2 days fa da KaySchmid
Postato : 17/03/2025 10:12 pm
RE: MMU3 Filamant Change Error
Maybe try the calibration test for the filament sensor (the one on top the extruder).
Postato : 18/03/2025 2:05 pm