Notifications
Clear all
Enclosure with MK3 & MMU2
IKEA Metod cabinet, my enclosure design with aluminium frame and acrylic glass walls and doors, Prusa i3MK3 with MMU2, octoPi print server on Raspberry Pi with 5MP IR camera, own design of ball-bearing spool holders and PTFE tube holders.
Enclosure keeps heat and noise inside, humidity out.
All filament is stored in 90um bags with Drypak 70g desiccant bags inside.
Great print results 😀
Napsal : 11/01/2019 3:22 pm
RE: Enclosure with MK3 & MMU2
Very nice 🙂 can you share your design?
Napsal : 23/12/2020 2:42 pm
Ty se líbí
RE: Enclosure with MK3 & MMU2
I have something very similar , but no where near as elegant. Those aren’t auto rewinding- and my similar set up spools will end up getting tangled because of then back feed during spool change. The inherent coil/twist of petg filaments can cause problems.
Napsal : 05/03/2021 6:04 am
RE: Enclosure with MK3 & MMU2
Do you have any problems when printing without buffer?
Napsal : 13/03/2021 9:18 pm