First layer problem - z set correctly, but
I have a first layer issues. Printing the Eclipson MXS-R V2.
All of their pre-prepared LW-PLA prints went perfectly.
Three of their pre-prepared PLA gcode prints went perfectly.
Then I started having a first layer issue. The prints were being airdropped from (-1,6 to 0.3) about 1 to 1.5 high.
What gcode would do this?
After 4-5 failed attempts, I rechecked my z setting and it was correct.
I started another print and did a live z adjust to get to the bed (say -2.8) Stopped that print.
Started another print from the new -2.8 and it still went to air print at the same starting height. Attempted another live z adjustment, but quit once I got past -3.5
So what line could there be in the G code that is causing an initial lift?
The code looks fine in Prusaslicer.