Notifications
Clear all
Topic starter
answered:
RE: ASA with HIPS support material
Printing ASA with HIPS was difficult. I maintained an enclosure between 64-65.5 deg Celsius at all times during the print. I had previously printed the same object at 55 deg Celsius but had some minor layer separation issues. The Einsy board is enclosed with a fan beneath supplying a mass flow rate of air acceptable to maintain the enclosure at 52 deg Celsius. All the extruder parts have been reprinted with polycarbonate. The power supply is outside the enclosure.
Napsal : 05/10/2022 7:50 am
Topic starter
answered:
RE: ASA with HIPS support material
Napsal : 18/10/2022 5:22 am