MMU load fail 3 times forward and retract. Better error coding required.

Pagina 2 / 2 Precedente

Ultimi post

RSS

B. Hudson

(@b-hudson)

Active Member

RE: MMU load fail 3 times forward and retract. Better error coding required.

@ab-2

Check that your MMU2 unit is functioning properly and the filament isn't binding. It sounds like the MMU2 feed motor is detecting too much pull on the filament and interpreting that as a blockage in the Bowden tube between the MMU2 and the extruder inlet. This may be due to a problem with the filament position or the filament itself; soluble filament is difficult to work with in the best of times I have found.

Postato : 02/02/2021 9:19 pm

Pagina 2 / 2 Precedente

Statistiche Forum

559 Forum

63.1 K Discussioni

444 K Post

21 Online

68.1 K Utenti

Post recenti: Some layers not lining up when slicing Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso