Notifications
Clear all
Idler motor driver no output
Hi All I am getting 0v output from P10, where P8 &P9 give 12v to the motors when my MMU2S board is powered on.
I suspect a driver fault, but is there anything else I could troubleshoot before I get a new board?
Best Answer by Loenja:
A reflow appears to have made at least some difference in my case.
Posted : 26/11/2020 3:30 pm
RE: Idler motor driver no output
I think you are right, but I would support in the chat.
--------------------
Chuck H
3D Printer Review Blog
Posted : 26/11/2020 9:12 pm
Topic starter
answered:
RE: Idler motor driver no output
A reflow appears to have made at least some difference in my case.
Posted : 03/12/2020 2:51 pm