Notifications
Clear all

BIGTREETECH MMU2-DIP V1.0 Control Board  

  RSS
BootStrap
(@bootstrap)
Active Member
BIGTREETECH MMU2-DIP V1.0 Control Board

Has anyone tried this as an alternative controller board for the MMU?     Over the 3 years I have been running the MMU I am on my 3rd board, each seems to at some point having issues that might be related to power.   I was thinking of trying the BIGTREETECH board but wanted to see if anyone had experience?

Looks like you buy the board as well as some stepper drivers.

Looking forward to your feedback!

https://biqu.equipment/products/bigtreetech-mmu2-dip-v1-0-control-board-3d-printer-part-for-original-prusa-i3-mk3s-prusa-i3-mk2-5s?variant=32024679481442&currency=USD&utm_medium=product_sync&utm_source=google&utm_content=sag_organic&utm_campaign=sag_organic&gclid=Cj0KCQiAsdKbBhDHARIsANJ6-jcnxUgU9Dso11O2OuLfexEGI_9jnlKxv6vdS0cC8p6LHU2wkRLN-cUaAuZNEALw_wcB

 

Posted : 16/11/2022 7:03 pm
Myf
 Myf
(@myf)
Estimable Member
RE: BIGTREETECH MMU2-DIP V1.0 Control Board

I'm not testing this card...

but mine flickers more and more until it's impossible to use. So I take the mmu apart.

If this card is better, I will reassemble my mmu...

Can I use the card alone or is it better to add two or three tmc2209 drivers?
Is there enough room in the original mmu case?

I hope we will have an answer!

Thank you for your new message !

Posted : 04/12/2022 7:30 pm
Share: