Anyone has STL to make LACK enclosure height of one of the compartments!

Dernier message

RSS

roshan.m

(@roshan-m)

New Member

Anyone has STL to make LACK enclosure height of one of the compartments!

I have a 3 x LACK enclosure and I use the top one for my MK3. I recently bought an ANYCUBIC MEGA-S and it's taller than the Prusa. I want to make the ANYCUBIC fit the middle compartment but it needs a good 3/4cms height increase to fit. Anyone has STLs for that?

https://inro.in/lucky-patcher/https://inro.in/9apps/https://inro.in/vidmate/

Publié : 01/02/2019 1:20 pm

Calire

(@calire)

Honorable Member

Re: Anyone has STL to make LACK enclosure height of one of the compartments!

With this https://www.thingiverse.com/thing:2012384 and possibility to remove the table.
Differents heights (upper leg V1 : 50mm, V2 : 95mm or V3 : 100mm and lower leg).

Publié : 01/02/2019 6:02 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

24 En-ligne

68.1 K Membres

Le dernier des messages: Upgrade path from MK3.5 to MK3.9s ? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé