Deutsch
Foren
English forum
Original Prusa i3 MMU2 & MMU2S
General discussion, announcements and releases
Anyone has STL to make LACK enclosure height of one of the compartments!
 
Benachrichtigungen
Alles löschen

Anyone has STL to make LACK enclosure height of one of the compartments!  

    Letzter Beitrag
  RSS
roshan.m
 roshan.m
(@roshan-m)
New Member
Anyone has STL to make LACK enclosure height of one of the compartments!

I have a 3 x LACK enclosure and I use the top one for my MK3. I recently bought an ANYCUBIC MEGA-S and it's taller than the Prusa. I want to make the ANYCUBIC fit the middle compartment but it needs a good 3/4cms height increase to fit. Anyone has STLs for that?

https://inro.in/lucky-patcher/https://inro.in/9apps/https://inro.in/vidmate/
Veröffentlicht : 01/02/2019 1:20 pm
Calire
 Calire
(@calire)
Honorable Member
Re: Anyone has STL to make LACK enclosure height of one of the compartments!

With this https://www.thingiverse.com/thing:2012384 and possibility to remove the table.
Differents heights (upper leg V1 : 50mm, V2 : 95mm or V3 : 100mm and lower leg).

Veröffentlicht : 01/02/2019 6:02 pm
  Alle Forumsthemen
  Vorheriges Thema
Nächstes Thema  
Teilen: