Notifications
Clear all

Layer shift on Y axis after mmu2 upgrade  

  RSS
David Wybourn
(@david-wybourn)
Eminent Member
Layer shift on Y axis after mmu2 upgrade

I had a perfectly working MK3 which I recently upgraded to the mmu2. This included a firmware update to 3.7.1.

After this upgrade I'm now getting weird layer shifts on the y axis at the beginning of every print. 

The upgrade had no changes on the y axis and I've checked the belts, both y and X are fine. 

Any idea what's causing this? 

Napsal : 05/07/2019 8:43 pm
messismore
(@messismore)
Active Member
RE: Layer shift on Y axis after mmu2 upgrade

I have the same problem I think. Went from MK3 to MK3S + MMU2S and ever since my print quality has been terrible. 

The reading for the Y belt tension was very high but I can’t get it below 275. I tensioned it to the point that I worry about the tensioner breaking. The X belt reads 250 but it’s way looser.  

(Print in the photo is Prusa PETG but the layer shifting occurs with every filament I’ve tried so far)

This post was modified před 5 years 2 times by messismore
Napsal : 15/07/2019 9:51 am
Share: