Avisos
Vaciar todo

Custom Himera Nozzle Replacement, original thread?  

  RSS
kaidoestech
(@kaidoestech)
Miembro
Custom Himera Nozzle Replacement, original thread?

(REPOST) Hey everyone! -- IMGUR LINK

Today I have an interesting request for members of the Prusa modding community.

I was gifted a Prusa i3 MK3s and it came with a nozzle replacement I was not immediately aware of.

It became clear, though, when upgrading the firmware to latest that I immediately began getting THERMAL ANOMALYies about 5 seconds into printing and Axis, Axis X errors upon running the selftest. 

Running some google lens scans, and talking to support agents led me to realize I have the https://e3d-online.com/products/hemera-xs-direct-kit -- V6 Himera Direct Kit. Further research led me to this thread -- Link -- and from there I tried to find an earlier version, to no avail. In the thread, the Himera is mounted rotated slightly, while mine is flat. I believe this is because my Himera nozzle configuration is from an earlier version of that thread which I have been unable to find. 

My request from the community is -- where is the old thread, where are the old instructions, and any more two cents you could contribute would be incredibly helpful.

Thanks a lot,

Kai

Respondido : 11/08/2024 2:12 am
Compartir: