Notifications
Clear all
Bontech extruder causing gaps
Modifications
Bondtech extruder
Mosquito magnum hot end
0.8 mm nozzle
0.4 mm nozzle
Prusamet filament
It seems like the extruder is not extruding enough filament
Settings:
0.25 and 0.3 layer height with the 0.8 mm nozzle
i can provide others if necessary i have read that retract can be influential but it is locked, i think it is a filament setting possibly.
This extruder either does this or it has the click of death it has been quite frustrating.
Publié : 05/05/2022 7:42 pm